Pc raid vista custom

Neon Axolotl Cursor Add. Minimal Axolotl Cursor Add. Shades of Purple Shades of a color that's bold as you are. Pokemon Skitty and Delcatty Cursor Add. All editor picks More. All cursor collecti ons Brawl Stars. Web Media. Marvel Comics. Hollow Knight. All forum topics Previous topic Next topic. I would try the following apart from the solution on the Microsoft link you posted : Install the 8.

I should be able to try Option 1 and post back. Copy link. In response to idata. Please report back. Thanks for the interesting reply.

I had lost hope. JimG, Unfortunately, I don't think I have good news for you. Alphastar, I was afraid you would not have good news. I did a little more digging, too. Can you say "Planned Obsolescence"?! So true. Alphastar, Thanks for the new info, but it's too late. Windows 7 is quite impressive, and I am a happy camper Thanks again for you efforts. Kurtsimon, Yes - see my last post.

Thanks, JimG. I'm on my way. Installed Windows 7 recently. Followed dlewisfl' instructions - downloaded the drivers that he linked to. Hi, I tried to use the utility to create the driver files to a floppy disk.

Hi there blend. As for the drives - you could remove one of the drives - so you're no longer in RAID setup. Wish you luck Message was edited by: steyrs. Load more replies. Post Reply. Adaptec , Promise and other vendors offer a wide selection of pricier, but more capable RAID adapters with onboard cache and advanced features. If possible, buy a card that supports greater-than With the advent of SATA, mixing vendors is no longer as problematic. Also, though there are controllers that allow mixing and matching capacities without losing storage space using advanced parity techniques , these are still relatively rare.

Alternatively, never touch exposed contacts or electronics. Unplug your PC and position the case so that you can comfortably reach into the interior. Typically, a single screw secures the bracket. Remove the adapter card from its packaging, handling the card by its edges not the edge connector on the bottom ; avoid touching the chips and circuitry on either face of the card. Secure the card to the chassis with the existing screw or other clamping mechanism. Once the card is installed, install and connect the hard drives to be used in the array.

Each RAID adapter has a firmware configuration program, unique to that make or model, that lets the user select the type of RAID array to install and choose which hard drives to include in the array. Refer to your adapter or motherboard documentation to guide you through the specific installation steps for your adapter. Be quick: You have only a few seconds to press F6 and launch the installation process. Press S. Once done, you should be able to see the drives attached to the RAID controller.

It can be difficult, and sometimes impossible to transfer an existing operating system installation to a RAID array. It all depends on the hardware and Windows operating system involved.

Follow the steps below for the best chance of success. Start over.